CleanStation Trouble Shooting
Need to contact Tech Suport? Click Here
CS2
Machine not starting:
– Check that the water level is high enough to float the level switch float. When the top two holes in the jet plate are covered or the water level is about 1″ from the top of the tank.
Machine will not drain:
– Check that the 3-way valve is fully rotated to “Drain Tank” position, to active the magnetic switch.
Machine Not heating:
– Check that the controller set point is set correctly.
More questions? Contact Tech Support: Click Here
DT3
Machine not starting:
– Check that the water level is high enough to float the level switch float. When the top two holes in the jet plate are covered or the water level is about 1″ from the top of the tank.
Not heating:
– Check that the controller set point is set correctly.
More questions? Contact Tech Support: Click Here
DT3-M
Machine not starting:
– Check that the water level is high enough to float the level switch float. When the top two holes in the jet plate are covered or the water level is about 1″ from the top of the tank.
More questions? Contact Tech Support: Click Here
CS2P
Machine not starting:
– Check that the water level is high enough to float the level switch float. When the top two holes in the jet plate are covered or the water level is about 1″ from the top of the tank.
Machine will not drain:
– Check that the 3-way valve is fully rotated to “Drain Tank” position, to active the magnetic switch.
Not heating:
– Check that the controller set point is set correctly.
More questions? Contact Tech Support: Click Here
XL-Plus
Machine not starting:
– Check that the water level is high enough to float the level switch float.
– Check that the 3-way valve is fully rotated to “Clean Parts” position.
Machine will not drain:
– Check that the 3-way valve is fully rotated to “Drain Tank” position, to active the magnetic switch.
Machine Not heating:
– Check that the controller set point is set correctly.
Contact Tech Support
(Red Asterisk = Required Field)